Running Message Queue service

Choose "Message Queue Control Panel" from program group of MailBee Message Queue. Control Panel applet appears.

To start the service, click Start button on Status tab. To stop the service, click Stop button.

You can always exit Control Panel applet by clicking OK or Cancel buttons. Exiting Control Panel does not terminate the service if it is already running.

On the first run, you need to configure Message Queue. The following settings must be specified:

License Key (located on Main tab) - you receive it when downloading or registering trial version of MailBee Message Queue
Queue Directory Path (located on Main tab) - pickup folder for Message Queue. Message Queue periodically polls this directory for new messages and sends them when they are found. You place messages to this directory by calling SendToQueue method of MailBee SMTP component (SubmitToPickupFolder for MailBee.NET SMTP component)
Server (located on SMTP tab) - your SMTP server name or IP address

There are some additional parameters you might need to set depending on your network configuration. See Configuring Message Queue topic for details.

See Also:

Configuring Message Queue service